Reset TPU

Steps:

1. insert key
2. turn until you see many indicator lights in your meter. (2 position)
3. press gas paddle for ..10 to 15 sec
4. keep your feet there, switch off ( turn key to 0 position)
5. release feet and hear small sound....(click sound)
6. done


This step are to reset the way you drive to default working mode. Now when you press the gas paddle, it will be smoother.!!!...

hope it helps!


Comments

Post a Comment

Popular posts from this blog

Mercedes w204 tail light holder - FIXED!!!

Image
Lately, while wife is driving and claims that she heard noise like a reversing sensor triggered, although without engaging reverse gears. Here goes the breakdowns. Symptoms: -reversing sound in cabin. -light blinking. Diagnosis: open up the back compartment to access the lights. Those light bulbs are attached to the holders. , check to see if there is burn patches...(mostly likely) For my case it is burned which is the usual case, and you will need to fixed it immediately as this is fire hazard. Parts: 1. you need: mine is the right side. (looking from the back) model A2048201600, surprisingly it all comes with bulbs attached. 2. those black connectors. (2115450328) 3. those pins ( not sure the part number, if anyone can help) I'd be gladly appreciate it. Tools: 1. wire cutter. 2. electrical tape 3. Pin remover tools 4. cloth 5.gloves. after replacing all those parts, test it , and check are those lights balance. if not , remove the other sid...
Read more

Purge Valve

Image
This page is to explain my issues with the purge valve, this valve have to be put back to it's original location else it will create a loud knocking noise under your dashboard...intermittently....about 5mins cycle when idling. So next time..if you ever hear some noise ...check this , make sure it's at it's holder. more details at the link below. http://www.pelicanparts.com/techarticles/Mercedes-W204/61-ENGINE-Purge_Valve_Replacement/61-ENGINE-Purge_Valve_Replacement.htm
Read more